| Full Fitting Instructions available below these photos | ||||
CASCADE PERMANENT PIPE REPAIR MADE QUICK AND EASY |
||||
|
||||
| Wrap clamp around the pipe. Bring together using locking washer plate. | ||||
|
||||
| Lock in place. Squeeze the lugs together & spin the nuts down. | ||||
|
||||
| Tighten the nuts evenly with a wrench - no rotating is necessary. | ||||
|
||||
|
Before
Fitting Clean the pipe where the clamp is to be
fitted Position the clamp so that the holes in
the pipe are in the centre of the clamp Mark the position on the pipe at each end
of the clamp Remove the clamp from the pipe Apply a suitable plumbing lubricant
smoothly on the whole area to be covered by the clamp Open the clamp by loosening the nuts to
the end of the bolts (do not remove the nuts)
Wrap the clamp around the pipe and engage
the washer plate/s behind the receiver plate/s Position the sides of the clamp to line up
with the marks you made ensuring that the hole/s are in the centre
of the clamp, make sure the gasket forms fully around the pipe, no
folds Position the bolts at 45 degrees to the
hole in the pipe, tighten the nuts to recommended torque (M16 135Nm)
(M12 95Nm) Tighten the bolts evenly and make sure the
gasket does not hook or fold, the gasket should fit smoothly around
the pipe Open the water or gas |
||||
|
Junior Coupling and Half Clamp Installation
instruction Before Fitting Clean the pipe where the clamp is to be
fitted Position the clamp so that the holes in
the pipe are in the centre of the clamp Mark the position on the pipe at each end
of the clamp Remove the clamp from the pipe Apply a suitable plumbing lubricant
smoothly on the whole area to be covered by the clamp
Half Clamp (code CFC) Unhitch the bolt head, spread lugs open,
snap into position over the leak and tighten to 20-25Nm. Repair is
complete. Junior Coupling (code CFW) Unhitch the bolt head, slide gasket out and wrap around leak. Spread lugs open, snap into position over the gasket, tighten to 20-25Nm, making sure that the armour plate’s centering nipples are positioned between the clamp’s ends. Repair is complete |
||||
| Download this page in PDF | Return to the top | |||
|
||||
|
||||
|
||||
